GE D.20 RIO Hardware User Manual page 50

CONFIGURATION RESTORATION
50
9. If the D.20 RIO's's IP configuration needs to be the same as that of the D.20 RIO from
which the configuration was copied, then skip this step. Otherwise, at the command
prompt, type d2riocfg and press Enter. Use the menu interface to change the D.20
RIO's IP configuration to what it needs to be and then exit back to the command
prompt.
10. At the command prompt, type sudo reboot, to reboot the D.20 RIO.
11. If the newly restored D.20 RIO configuration is exactly the same as the configuration
that was last retrieved from the D400 Configuration HMI, then skip this step.
Otherwise wait for the D.20 RIO to finish rebooting, and then retrieve the D.20 RIO
configuration from the D400 Configuration HMI.
12. Test the D.20 RIO functionality to ensure that the configuration has restored correctly.
Result: The D.20 RIO now has the same configuration files as the source D.20 RIO.
All username and password combinations configured on the destination D.20 RIO will be
overwritten with the values in the saved configuration files.
CHAPTER 5: BACKING UP AND RESTORING THE D.20 RIO
GE Information D.20 RIO - HARDWARE USER'S MANUAL