Table of Contents
Advertisement
CHAPTER 2: INSTALLING THE D.20 RIO
DIN rail mounting the D.20 RIO
To install the D.20 RIO
on a DIN rail:
Vertical mounting orientation
To attach the D.20 RIO
to a DIN rail:
To detach the D.20
RIO from a DIN rail:
D.20 RIO - HARDWARE USER'S MANUAL
The D.20 RIO can be attached to a standard 35 mm wide DIN rail in either the horizontal or
vertical position by installing the DIN rail mounting flange.
•
Attach the DIN rail mounting flange to the D.20 RIO in either the horizontal or vertical
orientation using the 8 screws provided with the flange. Tighten to 0.5 Nm.
See "DIN rail mounting" on page 27.
Figure 6: DIN rail mounting
1.
Slide the unit into the top lip of the rail until the brackets are securely fastened.
2.
Push the bottom of the unit into the lower lip of the rail until the bracket clicks into
place.
Hold the unit securely while you are attaching it to the DIN rail to prevent damage by
dropping it. Verify that the unit has been correctly installed before use by applying
light pressure in all directions.
1.
Push the button on the bottom of the bracket upwards with a screwdriver until the
base of the unit can be pulled slightly away from the lower lip of the DIN rail.
2.
Once the base is free, apply light upward pressure to dislodge the unit from the upper
lip of the rail.
Hold the unit securely while you are detaching it from the DIN rail to prevent damage
by dropping it.
Horizontal mounting orientation
GE Information
DIN RAIL MOUNTING THE D.20 RIO
27
Advertisement
Table of Contents
