Table of Contents
Advertisement
CHAPTER 4: SETTING UP THE D.20 RIO
Enabling LAN
redundancy
Configure secure access
Configure SSH service
Configure web mode
Configure
administrator only
logins
D.20 RIO - HARDWARE USER'S MANUAL
6.
Type 3 and press Enter to select 3. Remove VLAN.
Result: A list of configured VLANs appears.
7.
Remove all created VLAN IDs.
8.
Return to the Available Network Interfaces menu.
9.
Type 2 and press Enter to select: 2. Disable LAN Redundancy.
To enable LAN redundancy if the VLAN is configured in either NET1 or NET2 interfaces:
1.
Connect to the rear maintenance RS-232 port. See "D.20 RIO field and network
connectors" on page 29.
2.
At the D20RIO#>> prompt, type d20riocfg and press Enter.
Result: The D20RIO Configuration Utility menu appears.
3.
Type 3 and press Enter to select 3. Configure Network Interfaces.
Result: The Network Interface menu appears.
4.
Type 1 or 2 and press Enter to select either 1.Net1 or 2. Net2.
5.
Type 4 and press Enter to select 4. VLAN.
6.
Type 3 and press Enter to select 3. Remove VLAN.
Result: A list of configured VLANs appears.
7.
Remove all created VLAN IDs.
8.
Return to the Available Network Interfaces menu.
9.
Type 3 and press Enter to select: 3. Enable LAN Redundancy.
The Configure Secure Access menu allows you to configure the modes through which
users can access the D.20 RIO.
Enable or disable access to the D.20 RIO through the SSH protocol.
Select if users can access the D.20 RIO web interface through an HTTP connection or if
users should be redirected to an HTTPS connection.
Select if access to command-line utilities is restricted to Administrator-level users or not.
By default, this option is enabled. This setting restricts access to the following services:
•
Login
•
SSH
•
SFTP
GE Information
D.20 RIO CONFIGURATION UTILITY
43
Advertisement
Table of Contents
