Oce cm4520 User Manual page 335

7
4
Touch [Custom Size].
The Custom Size screen appears.
5
Type in the length (X) and width (Y) of the paper.
– Make sure that [X] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side X. (5-1/2 in. to 18 in.)
– Make sure that [Y] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side Y. (3-9/16 in. to 12-1/4 in.)
– If a decimal value is displayed in the screen, use the keypad to type
in the length. For details on switching between decimal and fraction
values, "System Setting" on page 12-17.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
? Can paper sizes be stored?
% Five non-standard paper sizes can be stored.
% To recall a stored paper size, touch the corresponding memory key.
% The names "memory1" through "memory5" can be changed. For
details on changing the names, refer to "To store a non-standard
paper size (Custom Size settings)" on page 7-16.
7-14
Copy Paper/Original Documents
cm4520