Removing The Pendulum Shaft - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
15. Remove the inner circlip (1) by the lower
bearing (see illustration). The rear
carriage is now loose and can be moved.
Then loosen the outer circlip (2) and
remove the bearing from below
16. Remove the upper bearings from above;
if they are stuck tap them from below.
17. Fit the new bearings and mount the
articulated steering in the reverse order
that it was removed.
18. After mounting, the cable tension should
be checked, see "Remove the frame
plate by loosening the screws (two on the
power steering housing)." on page 34.
Also check that the controls and cables
are properly adjusted, see "Adjusting the
Brake" on page 37, "Adjusting of the
Hydrostatic Transmission Cable" on
page 38, and for ProFlex 21 "Adjusting
the Differential Lock" on page 37.
19. Check the adjustment of the neutral
position contact. See "Microswitch:
Neutral Position" on page 80.
20. ProFlex 21
Bleed the hydraulic system. Top up the
oil after test running.

Removing the Pendulum Shaft

1. Jack up the rider in front of the rear
frame.
2. Remove the transmission cover.
3. Loosen the transmission oil tank and
move it out of the way in order to access
the brake cables.
4. ProFlex 21
Clean, see "Working Methods" on
page 82. Loosen the hydraulic hoses
from the hydrostatic transmission.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Lower bearings
Upper bearings
Jacking up
Hydraulic hoses
6012-027
6012-028
6012-029
8009-366
41
English-