For Husqvarna Parts Call 606-678-9623 or 606-561-4983
6.
Remove the hub using a puller. Do not
lose the key that sits between the hub
and the shaft.
7.
Remove the protective metal washer.
8.
Mark one end of the shaft. Push out the
shaft with a puller. Tap out the bearings
and remove the spacer.
You can purchase the entire assembly,
complete with shaft housing, shaft, spacer,
and bearings.
Fit in the reverse order to removal. Make
sure that the shaft is mounted in the same
direction as when it was removed, otherwise
the keys will not fit the grooves.
IMPORTANT INFORMATION
When tightening the blade shaft screws,
the transmission side should always be
tightened first and then the blade screws.
Tighten the blade bearings with a torque of
20-25 Nm (14-18) lbf. ft.
Tighten the blade bearings with a torque of
45-50 Nm (32-36) lbf. ft.
REPAIR INSTRUCTIONS
www.mymowerparts.com
Removing the hub
Removing the protective washer
Removing the shaft
Repair kit
6012-084
6012-085
6012-086
6012-087
71
English-