The Cutting Unit Components; Attaching The Cutting Unit - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

The Cutting Unit Components

In the instructions below, a cutting unit with a
rear ejector is shown, but the same principles
apply to all cutting units unless otherwise
stated.
The components mentioned are:
• A. Catch
• B. Interior plug
• C. Safety catch
• D. Handle
• E. Height adjustment handle
• F. Parallelism handle
• G. Lowest height adjustment stop

Attaching the Cutting Unit

!
WARNING!
Exercise caution.
Risk of crush injuries
Starting point for attaching the cutting unit:
• Place the machine on a flat surface.
• Lock the brake by pressing down the
pedal and locking with the push-button.
• Equipment hydraulics in the lower
position on ProFlex 21.
• Equipment frame in lowered position.
• Equipment frame locked with safety
catch and locks (A) in the inset position.
• Unit frame mounted on the cutting unit,
see "Removing the Unit Frame" on
page 69.
1. Attach the unit to the equipment frame's
outer hooks.
2. Pull out the catch (A) and loosen the
safety catch by pushing its handle (D)
back.
3. Raise the unit by pulling up the
mechanical lifting lever, located on the
driver's right side.
62
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
C
B
A
The Cutting Unit Components
Lock A inset position
Outer hooks
Lock and safety catch
D
E
G
F
8009-188
8009-022
8009-024
D
A
8009-167