Steering Wheel; Tow Hook; Checking The Engine Oil Level - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
DELIVERY AND DEALER SERVICE

Steering Wheel

• Fit the steering wheel with the steering
rod on the steering column. Choose a
suitable height position.
• Thread the Allen screw into the thread of
the steering column. Work the wheel
and tighten the Allen screw so that it
reaches the bottom of the thread.
• Fit the lock nut to the Allen screw.

Tow Hook

The tow hook is fitted the 'wrong' way at the
factory for transport reasons. Fit the tow
hook to the back of the bumper as illustrated.

Checking the Engine Oil Level

Check the oil level in the engine when the
Rider stands horizontal with the engine
switched off.
Open the engine cover.
Loosen the dipstick and pull it out. Wipe off
the dipstick and fit it again.
The dipstick shall not be screwed into place.
Pull out the dipstick and read the oil level.
The oil level should be between the markings
on the dipstick. If the level is approaching the
'ADD' mark, top up the oil to the 'FULL' mark
on the dipstick.
The oil is topped up through the hole the
dipstick sits in.
Use an engine oil with a viscosity indicated in
the chart, class SF-SJ.
The engine takes 1.5 litres (1.6 US qt) of oil
excl. the oil filter.
www.mymowerparts.com
Fitting the steering wheel
Fitting the tow hook
Dipstick
Oil level
Viscosity chart
8009-360
8009-112
8009-158
8009-159
8009-140
15
English-