Husqvarna Rider ProFlex 18 Workshop Manual page 88

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
5. Remove lever housing and lever. By
lifting the lever housing and twisting the
lever backwards, it can be unhooked
from the hole in the slider.
6. Remove the plastic plug and unscrew the
spring holder with a 12 mm Allen key.
7. Pull out the slider. Normally, the spring
does not need to be removed, but if it
does, only the hole in the slider may be
used to hold it in place.
8. Remove the steel ring and o-ring from
the rear section.
9. Remove the spacing ring and o-ring from
the front section.
10. Clean/replace the o-rings. Lubricate the
o-rings and the slider with motor oil
before assembly. The check valve can be
taken apart for cleaning, if necessary.
11. Lubricate and place the o-ring in its
position in the front section. Check that it
is properly seated.
12. Thread on the spacing ring (length 7 mm/
0.28") on the slider.
HYDRAULIC SYSTEM
www.mymowerparts.com
Lever housing with lever
Spring holder
Slider with spring
Steel ring and o-ring
8009-390
8009-391
8009-392
8009-393
87
English-