Husqvarna Rider ProFlex 18 Workshop Manual page 31

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
2. Fit the belt pulley with tool no. 506 56 06-
01 and tighten with a torque of 80 Nm/56
lbf. ft. Use tool no. 506 89 92-01 to
counter.
Place both belts in place on the belt
pulley.
3. Place the cables and hydraulic hoses in
the cable holder. Fit the cable holder and
belt guide. Adjust the belt guide against
the lower belt in the belt pulley as
needed.
4. Attach the throttle cable to the throttle
and fit the cable clip without tightening it.
Make sure that it goes into the proper
hole.
Move the accelerator to the full throttle
position. Push the cable's outer casing
as far to the left as possible and tighten
the cable clip.
Attach the choke cable to the carburettor
and fit the cable clip without tightening it.
Move the choke control to the full choke
position. Pull the cable's outer casing as
far to the right as possible and tighten
the cable clip.
5. Fit the muffler and exhaust pipe and
tighten the fixing screws and pipe
clamps.
30
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Engine belt pulley
Cable holder and belt guide
Throttle and choke cables
Exhaust system
506 56 76-01
8009-194
8009-364
8009-527
8009-193