The Cutting Unit's Service Position - Husqvarna Rider ProFlex 18 Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

The Cutting Unit's Service Position

In order to provide good accessibility for
cleaning, repair and servicing, the unit can be
set in the service position. The service
position means that the unit is raised and
locked in the vertical position.
Placing in the Service Position
1. Place the unit so that it hangs on the
outer hooks by carrying out steps 1-11
under "Removing the Cutting Unit" on
page 67.
2. Take hold of the unit's front edge and lift
it to a vertical position. The unit locks
automatically in the vertical position.
Releasing the Service Position
1. Ease up the unit's edge (tilt it back),
move the handle forward and slowly
lower the unit to the horizontal position.
2. Slide the unit into its operational position
by carrying out points 4-8 under
"Attaching the Cutting Unit" on page 62.
66
English-
REPAIR INSTRUCTIONS
www.mymowerparts.com
Service position
Release handle
8009-016
8009-015