Winview Recording - REXROTH VT-VRPD-2 Start-Up And Operation

RE 30126-01-B/08.07 | Manual

Winview recording

Winview recording –
File menu
Winview recording –
Help menu
Winview recording –
Toolbar
Trigger Setup
Recording Setup
Fig. 51 "Winview Recording" window
Corresponds to the BODAC main window "File Menu"
Takes you directly to help for the current topic or to the contents page of BODAC
windows help.
Buttons are provided for frequently used functions. These are described in section
"Toolbar".
The designation of the signals corresponds to the representation in the BODAC
Structure Editor, in which they are clearly represented on the basis of the input matrix,
the block matrix, the loop matrix and the output matrix.
Further information about the designation of signals that can be selected in BODAC
can be found in the chapter "Structure Editor".
Here, you can set the signal, which triggers the start of recording.
In this box you can set the conditions for signal recording. The number of points that
can be recorded is limited to 16384. This is valid for the total of all signals.
The record rate can be set within the range from 2ms to 32766ms. It is useful to select
only record rates that can be divided by 2.
The PreTrigger Points can be adjusted within a range from 0 to 163844ms. If the
trigger point occurs before the set pre-trigger points were recorded, fewer pre-trigger
points are shown on the signal display.
Hydraulics | Bosch Rexroth AG
BODAC – Menu Description 5
72/76