Connecting The Valve Position Transducer - REXROTH VT-VRPD-2 Start-Up And Operation

RE 30126-01-B/08.07 | Manual

Connecting the valve position transducer

Connection for the valve position transducer is shown in the following illustration.
Valve position feedback connection
Fig. 3 Connecting the valve transducer
The transducer is connected using a 4-pole cable connector Pg7-G5W1F, which can
be ordered separately under material number R900023126.
Cable 4 x 0.25 mm² of type LiYCY-CY ( 4 x 30 AWG Double shielded cable) is
recommended for lengths up to 50 m.
The shield should be connected to z10 on the edge connector of the controller on the
supply side only.
Hydraulics | Bosch Rexroth AG
Overview of the 4WRE 6 and 4WRE 10 – Valve control 2
4 2
1 3
13/76
z14
z12
z16
z18
z10
VPC D_06