User Interface Bodac - General; Software Tool And Data Handling; The Bodac Software; Data Exchange Between Bodac And The Vrpd - REXROTH VT-VRPD-2 Start-Up And Operation

RE 30126-01-B/08.07 | Manual
4

User interface BODAC - General

4.1

Software tool and data handling

The BODAC Software

Data exchange between BODAC and the VRPD

Create file

BODAC is a software tool for start-up. It must be installed on the PC or laptop you are
using for the initial startup.
BODAC stands for:
Bosch Rexroth Operator interface for Digital Axis Controller for in- and output
configuration, controller structure configuration, parameterisation, motion data and
diagnostics.
This software tool can be downloaded from the Internet at
http://www.boschrexroth.com/hacd.
Establish a connection between the PC and the VT-VRPD so that you can set, save
and duplicate the desired data.
The connection is based on RS232. A fixed baud rate is set in the card (57600 baud).
Ø
Use an RS232 cable (1:1 cable) to connect the PC to the VRPD.
Ø
Turn on PC and VRPD.
Ø
Install BODAC.
Ø
Start BODAC (see document RE 30126-B)
ü
BODAC automatically uploads the parameter set from the VRPD.
If BODAC does not upload automatically, no connection was made. In
this case check the "Configuration of the serial interface", the serial
connection and the supply voltage.
It is recommended that the parameter set be saved in a file. This allows you to restore
the current status of the VRPD at any time.
Assign a file name and save the initial param eter settings.
Hydraulics | Bosch Rexroth AG
User interface BODAC - General 4
34/76