REXROTH VT-VRPD-2 Start-Up And Operation page 31

RE 30126-01-B/08.07 | Manual
Motion data –
File menu
Motion data –
Controller menu
Motion data –
Help menu
Motion data –
Toolbar
Motion data
Fig. 15 "Motion Data" window
In the upper section the actual state of the VRPD is displayed with the parameter
"Binary call". If the Enable is set but the Binary valid signal is low Block 0 is called
regardless of the binary inputs setting.
The signals displayed in the middle portion of this window are the actual values of the
signals in the "Structure" window.
In the bottom part of the window the Digital inputs and outputs status is displayed
using ON/OFF.
Corresponds to the BODAC main window „File menu".
Contains commands for reading, writing and modifying parameters.
Takes you directly to the help for the current topic, or to the contents page of the
BODAC windows help.
Clicking on the oscilloscope symbol in the toolbar opens the BODAC
window "Multiplot". For more information see also Section "Multiplot".
The Data Log symbol in the toolbar generates a file with the extension
".log" in which all motion data are stored. For more information see
also Section "Creating a log file".
Selecting a signal for graphical representation is done by clicking on that signal in the
„Motion data" window. Deselecting a signal is done by clicking on this signal a second
time. When all the signals are marked the „multiplot" window can be opened by
clicking on the „Multiplot" icon in the toolbar. For more information see also Section
"Multiplot".
Hydraulics | Bosch Rexroth AG
Application: Valve control for the 4WRE6 / 4WRE10 3
31/76