Write Parameters; Set Parameters To Memory; Language - REXROTH VT-VRPD-2 Start-Up And Operation

RE 30126-01-B/08.07 | Manual

Write Parameters

Set parameters to memory

Language

English
Deutsch
The "Write parameters" command sends the settings and entries you made to the
controller card and overwrites the previously saved data in volatile memory.
NOTE!
The new data is available as long as the card has power.
If the card is disconnected from its power source, the data will be lost.
To save data permanently on the controller card, read the section "Set parameters to
memory".
Clicking on the preceding icon, which is also a component of the
toolbar, also sends the settings and entries you made to the card and
overwrites the previously saved data in volatile memory. A list of
existing shortcuts for the toolbar can be found in Section 4.2 "BODAC
Toolbar".
Sends the current data available in BODAC to the cards flash memory. This saves the
data to the non-volatile memory of the card so it is still available after a power
interruption.
The preceding icon, which is a component of the toolbar, sends the
current data from BODAC to the card non-volatile memory. A list of
existing shortcuts for the toolbar can be found in Section 4.2 "BODAC
Toolbar".
The "Language" menu point contains the following options:
n
English
n
Deutsch
Clicking on the preceding icon, which is a component of the toolbar,
opens a selection menu in which you can also select the language. A
list of existing shortcuts for the toolbar can be found in Section 4.2
"BODAC Toolbar".
Displays all the entries, windows, menus, etc. in English.
Displays all the entries, windows, menus, etc. in German.
NOTE!
Hydraulics | Bosch Rexroth AG
BODAC – Menu Description 5
44/76