REXROTH VT-VRPD-2 Start-Up And Operation page 70

RE 30126-01-B/08.07 | Manual Hydraulics | Bosch Rexroth AG 70/76
BODAC – Menu Description 5
Deletes the cursors for the X and Y coordinates from the signal
display.
Opens a window in which you can set the start condition for displaying
the signal plot. A selection menu is used to determine the signal for the
start condition. In the "Trigger Units" entry field the value of the trigger
parameter in units [Unit] is entered. This value is used to start the
signal plot.
The signal display is shown in X- and Y-coordinates with green grid
lines. The X-coordinate division can be changed by clicking on the
preceding field. In the current representation the signal travels 1
1 s/div
division in the X direction in one second.
To learn how to change the division of the Y-coordinate, refer to
section "Multiplot signal display legend".
Increases the current Timebase setting with one step. If the current
setting is 1s/div this function would increase the X-axis to 500ms/div.
Decreases the current Timebase setting with one step. If the current
setting is 1s/div this function would decrease the X-axis to 2s/div
The user can zoom in on a selected area of the Multiplot window.
Reset the multiplot back to its original size.