Ssh Connection Via The Management Lan Interface (Optional); Snmp Configuration (Optional) - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

3.1.4 SSH Connection via the Management LAN Interface (Optional)

This device supports the "SSH server function". This function is remote connection like "Telnet server function".
After executing "ssh-server" command, the "SSH-server" is enabled and authentication key is generated (It takes some time to
generate authentication key).
The following shows the "SSH-server function" supported by this device.
Protocol Version
Method of authentication
Authentication key
Method to generate
authentication key
Method of coding
Terminal sessions
Message authentication
code
The "SSH server function" via the management LAN interface is initially disabled.
To change the monitoring time for the SSH connection, carry out the following procedure in the administrator EXEC mode.
xg# configure terminal
xg(config)# ssh-server
xg(config)# terminal timeout vty <0-60>
xg(config)# exit
The "SSH-server function" supported by this device uses Open SSH free software that is published based on BSD licence.
Please refer to the following URL for more details.
http://www.openssh.com/

3.1.5 SNMP Configuration (Optional)

To operate in conjunction with an SNMP manager, the SNMP agent must be configured.
To configure the SNMP agent, carry out the following procedures in the administrator EXEC mode.
xg# configure terminal
xg(config)# hostname HOST-NAME
xg(config)# snmp-server location
SYSTEM-LOCATION
xg(config)# snmp-server contact
SYSTEM-CONTACT
xg(config)# snmp-server access host
{A.B.C.D|HOSTNAME} community COMMUNITY-NAME
xg(config)# snmp-server trap host
{A.B.C.D|HOSTNAME} community COMMUNITY-NAME
[protocol {v1|v2c}]
xg(config)# exit
Function
v2
Password
RSA(2048bits, fixed), DSA(1024bits, fixed)
Automatically generated, CLI
aes128-cbc,3des-cbc,blowfish-cbc,cast128-cbc,arcfour128,ar
cfour256,arcfour,aes192-cbc,aes256-cbc,aes128-ctr,aes192-c
tr,aes256-ctr
Maximum 4
(including Telnet connection)
hmac-md5,hmac-sha1,umac-64@openssh.com,hmac-ripemd
160,hmac-sha1-96,hmac-md5-96
Command
Command
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Support
Switch to global configuration mode.
Enable SSH connection
(Optional)
If the SSH session timeout period (in minutes) expires the
SSH connection is terminated.
Exit to administrator EXEC mode.
Switch to global configuration mode.
Set the switch name (HOST-NAME), switch's location
(SYSTEM-LOCATION), and contact
(SYSTEM-CONTACT).
Set the IP address (host name) of the SNMP manager and
the community name.
Set the IP address (host name) of the host that is notified
of SNMP traps and community name, if the SNMP trap
notification is enabled.
Exit to administrator EXEC mode.
25/315
Task
Task