Shutdown (Interface Edit Mode); Shutdown (Global Configuration Mode) - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.10.10 shutdown (Interface edit mode)

Function
Shuts down the ports so that they cannot be used.
Use the no form to enable the ports again.
Prompt
xg(config-if)# or xg(config-agg)#
Command syntax
shutdown
no shutdown
Command type
Configuration command
Default
None
Note
When this command is invoked, the port becomes disabled but the optical signal from the XFP is not stopped.
Example
Shut down switch port 3. Then, make it usable again.
xg(config)# interface port 3
xg(config-if)# shutdown
xg(config-if)# no shutdown

5.10.11 shutdown (Global configuration mode)

Function
Shuts down the ports from the global configuration mode so that they cannot be used.
Use the no form to enable the ports again.
Prompt
xg(config)#
Command syntax
shutdown port <1-20> [ <1-20> ]
no shutdown port <1-20> [ <1-20> ]
Parameter
port <1-20> [ <1-20> ]
Specifies the port number to shut down or enable.
When specifying multiple ports, list them separated with " " (space).
Command type
Configuration command
Default
None
Note
When this command is invoked, the port becomes disabled, but the optical signal from the XFP is not stopped.
To shut down an aggregation group, use the interface edit mode shutdown command.
Example
Shut down switch ports 3 and 4 then, make them usable again.
xg(config)# shutdown port 3 4
xg(config)# no shutdown port 3 4
151/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009