Storm-Control; Suppress-Address-Learning - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.10.8 storm-control

Function
Enables broadcast storm control for the designated ports.
Use the no form to disable storm control.
Prompt
xg(config-if)# or xg(config-agg)#
Command syntax
storm-control
no storm-control
Command type
Configuration command
Default
None
Note
When a broadcast storm condition is detected, the port will be in a violation state. After eliminating the cause of the
condition, clear the violation state with the "clear violation" command.
Example
Enable broadcast storm control for Port 3 of the switch.
xg(config)# interface port 3
xg(config-if)# storm-control

5.10.9 suppress-address-learning

Function
Disables the dynamic learning of the MAC address table for switch ports.
Use the no form to enable learning.
Prompt
xg(config-if)#, or xg(config-agg)#
Command syntax
suppress-address-learning
no suppress-address-learning
Command type
Configuration command
Default
None
Example
Disable dynamic learning for the MAC address table.
xg(config-if)# suppress-address-learning
150/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009