Features - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

1.1 Features

The XG2000 series is a compact, 20-port 10 Gigabit Ethernet Layer 2 switch.
Special features of the XG2000 series are shown below:
Item
Basic Switch Functions
Scalability
Redundancy
VLAN support
QoS
Multi-cast support
Network Management
Operation
management
Function
Throughput
Latency
Switching mode
MAC address learning table
size
MAC address learning
Jumbo frame support
Flow control
Storm control
Port security
Ingress rate control
Port mirroring
Link pass through
Link aggregation
(Static and LACP)
Uplink Filter
IEEE802.1D STP,
IEEE802.1w RSTP
IEEE802.1Q VLAN
Filtering
Multiple VLAN
IEEE802.1p QoS
DiffServ
Scheduling
IGMP snooping
Traffic statistics
SNMP agent
Console by
serial/management LAN
CLI
Remote authentication
11/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Features
400Gbit/s
350ns (Exclude latency of XFPs)
Either store-and-forward or cut-through is selectable.
16384 entries
SVL (Shared VLAN Learning), IVL (Independent VLAN Learning),
user selectable.
Up to 16KB (16128 bytes).
IEEE802.3x compliant pause frame control. Possible to specify flow
control options for each port.
Detects the broadcast storm status to prevent the traffic from
overflowing the network and avoid degrading overall system
performance.
Possible to restrict port access based on a source MAC address.
Supports by-port ingress rate control.
Possible to monitor the incoming/outgoing traffic by port mirroring.
Possible to synchronize the link state of a monitored port with the
link state of a single or multiple ports.
Possible to increase bandwidth and redundancy. (Up to 10 ports for
each link).
Also supports IEE802.3ad LACP.
Filtering multicast, broadcast and unlearned unicast frames from
leaf nodes to uplink. Possible to configure fat tree using several XG
series.
Possible to make a redundant and loop-free network using Rapid
Spanning Tree Protocol (upward compatible with Spanning Tree
Protocol).
Max. 128 groups.
Ingress/egress filtering
Possible to create multiple tag-based VLAN, with user VLAN tag
identifier.
Supports 4 traffic classes based on VLAN priority or DSCP
(DiffServ Code Point) of IPv4/IPv6.
Strict, DRR(Deficit Round Robin), Strict+DRR
Prevents unnecessary forwarding of multicast traffic to ports to
reduce unnecessary multicast traffic.
Possible to analyze traffic and errors, using traffic statistics.
Can be used in conjunction with an SNMP manager, supporting
MIBs, including Standard MIB, Bridge MIB, and RMON MIB.
Dedicated management LAN is isolated from the serial interface
and 10 Gigabit ports to secure the device.
Allows the user to provide environment settings and operation
management using command line interface (CLI).
RADIUS and TACACS+