Snmp Setup Commands; Show Snmp-Server - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.17 SNMP Setup Commands

This section explains the SNMP configuration settings.

5.17.1 show snmp-server

Function
Displays the current SNMP settings.
Prompt
xg> or xg#
Command syntax
show snmp-server
Command type
Operation management command
Output form
xg# show snmp-server
SNMP Information
===============================================================================
SNMP Manager Information
-------------------------------------------------------------------------------
[No.1]
Host
Community : public
[No.2]
Host
Community : public
-------------------------------------------------------------------------------
SNMP Trap Manager Information
-------------------------------------------------------------------------------
[No.1]
Host
Community : public
Version
[No.2]
Host
Community : public
Version
===============================================================================
SNMP Manager Information
Displays the current settings of the SNMP manager.
[No.1]
Indicates the number of the SNMP manager displayed. A maximum of four may be defined.
Host
Displays the host name or the IP address of the SNMP manager.
Community
Displays the community name of the SNMP manager.
SNMP Trap Manager Information
Displays the destination SNMP trap being set from the system.
[No.1]
Indicates the number of the SNMP trap item displayed.
Host
Displays the host name or the IP address of the SNMP manager for trap notification.
Community
Displays the community name of the SNMP manager for trap notification.
Version
Displays the SNMP protocol version to be used for trap notification as follows:
−
−
: 192.168.41.24
: 192.168.41.29
: 192.168.41.24
: { v1 | v2c }
: 192.168.41.29
: { v1 | v2c }
v1
The SNMP v1 protocol is used for trap notification.
v2c
The SNMP v2c protocol is used for trap notification.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
2007/01/22-06:04:41
233/315