Logout / Quit - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.4.6 logout / quit

Function
Logs out and disconnects the terminal session.
Prompt
xg> or xg#
Command syntax
Logout
Command type
Operation management commands
Example
Log out and disconnect the terminal session.
xg# logout
Connection closed by foreign host.
5.4.7 do
Function
Executes administrator exec mode commands from the global configuration mode.
Using this command saves the trouble of having to return to the administrator exec mode.
Prompt
xg(config)#
Command syntax
do LINE
Parameter
LINE
Specifies the command line for the administrator exec mode to execute.
Command type
Operation management commands
Message
Can't execute this command.
Explanation
The specified command cannot be executed with the do command.
Solution
Execute the command in an appropriate mode without using the do command.
Example
Set "bridge aging-time" from the global configuration mode. And then, without returning to the administrator exec mode, check
the setting status using the "show bridge" command.
xg(config)# bridge aging-time 200
xg(config)# do show bridge
Switch Basic Information
================================================================
Aging Time
Cut-through Switching
Jumbo Frame Support
Independent-vlan-learning: Enabled
DiffServ ToS
================================================================
: 200 (sec)
: Enabled
: Enabled Max Frame Size: 9216 (byte)
: Disabled
76/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
2007/01/22-12:16:17