Spanning-Tree Path-Cost-Default - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.11.9 spanning-tree path-cost-default

Function
Sets the version of path cost (IEEE802.1D: 16bits or IEEE802.1D:32bits) to be used for the Spanning Tree Protocol.
Use the no form to return to the default setup.
Prompt
xg(config)#
Command syntax
spanning-tree path-cost-default { 16bit | 32bit }
no spanning-tree path-cost-default
Parameter
path-cost-default { 16bit | 32bit }
−
−
Command type
Configuration command
Default
32bit
Message
% The Setting becomes an availableness by doing REBOOT.
Explanation
The settings changed will become valid when the system is restarted.
Solution
To make the settings valid, issue the "copy running-config startup-config" command first.
Then, issue the "reset" command to restart the system.
Example
Use the 32-bit path cost:
xg(config)# spanning-tree path-cost-default 32bit
16bit
IEEE802.1D (16bits) will be used for the path cost. The default path cost is 2.
32bit
IEEE802.1D (32bits) will be used for the path cost. The default path cost is 2000.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
167/315