Using The Monitor Command - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide
In the following example, show command output is redirected to TFTP server "remote-host1" using "| tftp".
xg# show startup-config | tftp remote-host1 restore_ startup_09302005
xg# show running-config | tftp remote-host1 restore_running_09302005
xg# show system information | tftp remote-host1 restore_system_09302005
In the following example, show command output is redirected to SSH server "remote-host2" using "| scp".
xg# show startup-config | scp foo remote-host2 restore_ startup_07012008
remote-host2's password:
xg# show running-config | scp foo remote-host2 restore_running_07012008
remote-host2's password:
xg# show system information | scp foo remote-host2 restore_system_07012008
remote-host2's password:
"scp" supports only password authentication, and this device can register up to 10 public keys of SSH
servers.
Execute "clear ssh-rhost-key" command to delete a registered public key.

2.2.12 Using the monitor Command

The monitor command provides additional key commands to perform screen navigation.
The following table shows the keys used to perform screen-related operations.
Displayed item
ESC:exit
F:refresh
U:page up
D:page down
L:page left
R:page right
Press the [Esc] key to close the monitor screen.
Press the [F] or [f] key to refresh the screen.
Press the [U] or [u] key to scroll up to the previous page.
If the current page is the first page of the display nothing occurs.
Press the [D] or [d] key to scroll down to the next page.
If the current page is the last page of the display, nothing occurs.
Press the [L] or [l] key to scroll the screen to the left.
If there are no additional columns of data to the left to display, nothing occurs.
Press the [R] or [r] key to scroll the screen to the right.
If there are no additional columns of data to the right of the display, nothing occurs.
21/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Meaning