Brother DCP-9040CN Service Manual page 84

(10) Video signal reception
Code 1 Code 2
A0
A0
A0
A0
A0
A0
A0
A0
A0
A8
A9
AA
(11) General communications-related
Code 1 Code 2
B0
B0
B0
BF
BF
BF
* Establishment of FAX communication:
FAX communication is established when the calling station receives a DIS (reception
capability) signal from the called station and the called station receives a NSS or DCS
(communications test) signal from the calling station.
(12) Maintenance mode
Code 1 Code 2
E0
E0
(13) Equipment error
Code 1 Code 2
FF
03 Error correction sequence not terminated even at the final
transmission speed for fallback.
11 Receive buffer empty. (5-second time-out)
12 Receive buffer full during operation except receiving into memory.
13 Decoding error continued on 500 lines or more.
14 Decoding error continued for 10 seconds or more.
15 Time-out: 13 seconds or more for one-line transmission.
16 RTC not found or carrier OFF detected for 6 seconds.
17 RTC found but no command detected for 60 seconds or more.
19 No video data to be sent
01 RTN, PIN, or ERR received at the calling terminal. *
01 RTN, PIN, or ERR received at the called terminal. *
18 Receive buffer full during receiving into memory.
02 Unable to receive the next-page data.
03 Unable to receive polling even during turn-around
transmission due to call reservation.
04 PC interface error.
01 Communication canceled by pressing the Stop/Exit button
before establishment of FAX communication*.
02 Communication canceled by pressing the Stop/Exit button
after establishment of FAX communication*.
03 Transmission canceled due to a scanning error caused by no
document or document feed problem in ADF scanning in real
time transmission.
01 Failed to detect 1300 Hz signal in burn-in operation.
02 Failed to detect PB signals in burn-in operation.
X X Equipment error
(For X X, refer to
1-65
Causes
* Available in German models only
Causes
Causes
Causes
"2.1 Error Indication")
Confidential