Brother DCP-9040CN Service Manual page 437

< WSW58 >
Selector No.
Prevention of line interrupt
1
during ICM recording (ratio of
guard tone response time to call
|
end tone ON time)
3
(Not used.)
4
| Not used.
7
Improvement of DTMF
8
detecting function
Note:
Selectors 1 through 3 are applicable only to models equipped with built-in TADs.
- Selectors 1 through 3: Prevention of line interrupt during ICM recording (ratio of guard
If an ICM tone is detected as a call end tone by error, this machine will release the line
even during ICM recording. To avoid this problem, change the setting for the ratio of guard
tone response time to the call end tone ON detection time.
If the actual percentage of guard tone response time is greater than the percentage set by
selectors 1 through 3, this machine will judge that the call end tone has not yet been
detected and will continue ICM recording.
< WSW59 >
Selector No.
USB serial number (SN)
1
transmission enabled/disabled
2
| Not used.
8
- Selector 1: Frame length selection
This is intended to prevent the problem of a continued increase in USB ports when serial
numbers are transmitted from the MFC to a Windows Vista-based PC.
It is intended only to prevent a problem specific to Windows Vista; its default setting is "0:
USB SN enabled."
Function
tone response time to call end tone ON time) (Not used.)
Function
App. 1-62
Setting and Specifications
No. 1 2 3
0 0 0: Invalid
0 0 1: 10 %
0 1 0: 20 %
0 1 1: 30 % (Default)
1 0 0: 40 %
1 0 1: 50 %
1 1 0: 60 %
1 1 1: 70 %
0: OFF
Setting and Specifications
0: USB serial number transmitted/ USB
serial number not transmitted
1: Frame length selection
1: ON
Confidential