10Base-T Device - D-Link DES-3326 User Manual

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
A 100BASE-TX hub or switch can be connected to the Switch
via a two-pair Category 5e UTP/STP straight cable.
If the other switch or hub contains an unused Uplink port, we
suggest connecting the other device's Uplink (MDI-II) port to any
of the switch's (MDI-X) ports (1x - 22x, or one of the optional
Gigabit module ports) using a normal straight-through cable, as
shown below.
If the other device does not have an unused Uplink port, make the
connection with a normal straight-through cable from the Uplink
port on the switch to any normal crossed port on the hub.
Alternatively, if you have a crossover cable you can save the
Uplink ports for other connections and make this one from a
crossed port to another crossed port.
Figure 4-2. Switch connected to a normal (non-Uplink) port on a hub
or switch using a straight or crossover cable

10BASE-T Device

For a 10BASE-T device, the Switch's LED indicators should display
the following:
100 LED speed indicator is OFF.
Link/Act indicator is ON.
26
Connecting The Switch