10Base-T Device; 100Base-Tx Device - D-Link DES-3225G Series User Manual

24-port NWay Ethernet Switch User's Guide
A 100BASE-TX hub or switch can be connected to the Switch via a two-pair Category 5 UTP/STP straight cable.
If the other switch or hub contains an unused Uplink port, we suggest connecting the other device's Uplink (MDI-II) port to
any of the switch's (MDI-X) ports (1x - 22x, or one of the 100BASE-TX module ports) using a normal straight-through cable,
as shown below.
If the other device does not have an unused Uplink port, make the connection with a normal straight-through cable from
one of the Uplink ports on the switch to any normal crossed port on the hub. Alternatively, if you have a crossover cable you
can save the Uplink ports for other connections and make this one from a crossed port to another crossed port.
Figure 4-2. Switch connected to a normal (non-Uplink) port on a hub or switch using a straight or crossover

10BASE-T Device

For a 10BASE-T device, the Switch's LED indicators should display the following:
100M LED speed indicator is OFF.
Link/Act indicator is ON.

100BASE-TX Device

For a 100BASE-TX device, the Switch's LED indicators should display the following:
100M LED speed indicator is ON.
Link/Act is ON.
Connecting The Switch
cable
13