Rear Panel - D-Link DES-3326 User Manual

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
A front-panel slide-in module slot for Gigabit Ethernet ports
can accommodate a 2-port 1000BASE-T Gigabit Ethernet
module, a 2-port 1000BASE-SX Gigabit Ethernet module, a
2-port 1000BASE-LX Gigabit Ethernet module, or a 2-port
GBIC-based Gigabit Ethernet module.
One switched MDI-X/MDI-II Uplink port that can be used to
connect a straight-through cable or a crossed cable to a
normal (non-Uplink) port on a switch or hub. This port is
identical to the other 23 ports except for the ability to use a
crossed or a straight-through cable.
Twenty-three high-performance, NWay Ethernet ports all of
which operate at 10/100 Mbps for connections to end
stations, servers and hubs. All ports can auto-negotiate
between 10Mbps or 100Mbps, full or half duplex, and flow
control.

Rear Panel

The rear panel of the switch consists of a slot for the optional DPS-
1000 (Redundant Power Supply) and an AC power connector.
Figure 3-2. Rear panel view of the Switch
The AC power connector is a standard three-pronged
connector that supports the power cord. Plug-in the female
connector of the provided power cord into this socket, and the
male side of the cord into a power outlet. Supported input
voltages range from 100 ~ 240 VAC at 50 ~ 60 Hz.
18
Identifying External Components