Defining Static Routes; Connecting To The Switch - D-Link DES-3326 User Manual

DES-3326 Layer 3 Fast Ethernet Switch User's Guide

Defining Static Routes

Routes between the IP interfaces and a default gateway or other
router with a WAN connection should be determined beforehand
and entered into the static/default routing table on the DES-3326.

Connecting to the Switch

You can use the console interface by connecting the Switch to a
VT100-compatible terminal or a computer running an ordinary
terminal emulator program (e.g., the terminal program included
with the Windows operating system) using an RS-232C serial
cable. Your terminal parameters will need to be set to:
VT-100/ANSI compatible
9,600 baud
8 data bits
No parity
One stop bit
No flow control
You can also access the same functions over a TELNET interface.
Once you have set an IP address for your Switch, you can use a
TELNET program (in VT-100 compatible terminal mode) to access
and control the Switch. All of the screens are identical, whether
accessed from the console port or from a TELNET interface.
118
Configuring the Switch Using the Console Interface