D-Link DES-3326 User Manual page 150

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Ethernet interface used for in-band communication, and the SLIP
interface used over the console port for out-of-band communication.
The fields listed under the Current Settings heading are those
that are currently being used by the switch. Those fields listed
under the Restart Settings heading are those which will be used
after the switch has been Rebooted.
Toggle the Get IP From: <
from Manual, BOOTP, or DCHP. This selects how the switch
will be assigned an IP address on the next reboot (or startup).
The Get IP From: < > options are:
BOOTP - The switch will send out a BOOTP broadcast
request when it is powered up. The BOOTP protocol
allows IP addresses, network masks, and default
gateways to be assigned by a central BOOTP server. If
this option is set, the Switch will first look for a BOOTP
server to provide it with this information before using
the default or previously entered settings.
DCHP – The switch will send out a DCHP broadcast
request when it is powered up.
allows IP addresses, network masks, and default
gateways to be assigned by a DCHP server.
option is set, the switch will first look for a DCHP server
to provide it with this information before using the
default or previously entered settings.
Manual – Allows the entry of an IP address, Subnet
Mask, and a Default Gateway for the switch. These
fields should be of the form xxx.xxx.xxx.xxx, where each
xxx is a number (represented in decimal form) between
0 and 255. This address should be a unique address on
the network assigned
Administrator. The fields which require entries under
this option are as follows:
136
Configuring the Switch Using the Console Interface
> field using the space bar to choose
The DCHP protocol
for use by the
If this
Network