D-Link DES-3326 User Manual page 165

DES-3326 Layer 3 Fast Ethernet Switch User's Guide
Figure 6-27. Layer 3 – Setup RIP Menu
Interface Name:[ ] is the name of the IP interface on which
RIP is to be setup. This interface must be previously configured on
the switch.
Authentication:<Enabled> is toggled between Enabled and
Disabled. When authentication is enabled, a password is used to
authenticate communication between routers on the network.
Authentication is only supported when RIP is in V1 Compatible or
V2 mode.
Password:[ ] is a password to be used to authenticate
communication between routers on the network.
TX Mode:<V2 Only> is toggled between Disabled, V1 Only, V1
Compatible, and V2 Only. This entry specifies which version of
the RIP protocol will be used to transmit RIP packets. Disabled
prevents the transmission of RIP packets.
RX Mode:<V2 Only> is toggled between Disabled, V1 Only, V2
Only, and V1 and V2. This entry specifies which version of the
Configuring the Switch Using the Console Interface
151