10Base-T Device; 100Base-Tx Device - D-Link DES-3624 Series User Manual

Stackable nway ethernet switch
Hide thumbs Also See for DES-3624 Series:
Table of Contents

Advertisement

♦ A 10BASE-T hub or switch can be connected to the Switch via a two-pair Category 3, 4 or 5 UTP/STP
straight cable.
♦ A 100BASE-TX hub or switch can be connected to the Switch via a four-pair Category 5 UTP/STP
straight cable.
If the other switch or hub contains an unused Uplink port, we suggest connecting the other device's Uplink
(MDI-II) port to any of the switch's (MDI-X) ports (1x - 22x, or one of the 100BASE-TX module ports) using a
normal straight-through cable, as shown below.
If the other device does not have an unused Uplink port, make the connection with a normal straight-through
cable from one of the Uplink ports on the switch to any normal crossed port on the hub. Alternatively, if you
have a crossover cable you can save the Uplink ports for other connections and make this one from a crossed
port to another crossed port.
Figure 4-2. Switch connected to a normal (non-Uplink) port on a hub or switch using a straight or crossover

10BASE-T Device

For a 10BASE-T device, the Switch's LED indicators should display the following:
♦ 100M LED speed indicator is OFF.
♦ Link/Act indicator is ON.

100BASE-TX Device

For a 100BASE-TX device, the Switch's LED indicators should display the following:
♦ 100M LED speed indicator is ON.
♦ Link/Act is ON.
28
Stackable NWay Ethernet Switch User's Guide
cable
Connecting The Switch

Advertisement

Table of Contents
loading

This manual is also suitable for:

3624i - des switch - stackable

Table of Contents