Table of Contents
Advertisement
This means that you will have one available IDE channel for 2 SATA drives to
use (each IDE channel can support 2 IDE drives). If you were to install all both
IDE drives and 4 SATA drives, you will only see 2 of the SATA drives along with
the 2 IDE drives.
Enhanced Mode
In this mode, you can use all 6 hard disk drives (including 2 IDE drives and 4
SATA drives). Note: You cannot use "Enhanced" mode with Windows® 98/ME.
It only support to install Windows® 2000/ XP if you want to boot from SATA
device. (It's restriction from Microsoft.)
SATA Only
Select this option when you install SATA drives only.
PATA IDE Mode
This item allows you to select an IDE channel for PATA IDE devices. When you install the SATA
device(s) to the SATA1 or 3 or 1+3, this item should be set to channel 1. When you install the device(s)
to the SATA2 or 4 or 2+4, this item should be set to channel 0.
Options: Channel 0 (default)、channel 1
SATA Port
This item will display which IDE channel will be used to the SATA device.
Options: SATA2, 4 is channel 1
Onboard Device
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: Enabled (default)、Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board. You
will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
USB Keyboard Support
Enables support for USB attached keyboards. Options: Disabled (default)、Enabled
Audio Device
This item allows you to control the onboard audio. Options: Auto (default)、Disabled
10/100 Mb LAN Device
This item allows you to enable or disable the 10/ 100 Mb LAN Device. Options: Enabled (default)、
Disabled
Gigabit LAN Device
This item allows you to enable or disable the Gigabit LAN Device. Options: Enabled (default)、Disabled
PX915P4/ PX915G4 Series
34
Advertisement
Table of Contents
