Connectors; Fdc - Albatron PM266A PRO User Manual

C onnectors
Floppy Disk Connector: FDC
This mainboard provides a stand
1.44M and 2.88M floppy diskettes.
in the packaging.
Hard Disk Connectors: IDE1-2
This mainboard has a 32-bit Enhanced PCI IDE Controller that supports PIO Mode 4, DMA mode,
Ultra ATA 66/ 100/ 133. This mainboard provides two IDE connectors, IDE1 (primary) and IDE2
(secondary).
IDE1 (Primary IDE Connector)
You can connect up to two hard drives to IDE1. If you attach two drives, you must use a ribbon cable
with three connectors. You must also configure one drive as the master and one
using the jumpers located on each drive.
IDE2 (Secondary IDE Connector)
The IDE2 connector can also support a Master and a Slave drive. The configuration is similar to
IDE1. The second drive on this controller must be set to slave mode.
ard floppy disk connector (FDC) that supports 360K, 720K, 1.2M,
This connector supports the floppy drive ribbon cables provided
DIM M1
DIM M2
14
PM266A PRO/ PM266A
drive as the slave,
IDE1
IDE2

FDC