Front Panel Indicator: Sw/Led、Pwrled - Albatron PM266A PRO User Manual

Front Panel Indicator: SW/LED、PWRLED
These headers are used to attach to indicators on t
(+)
(-)
(-)
(+)
Pin Assignment Function Pin Assignment Function
1
HD LED (+)
3
HD LED (-)
5
Reset Control (-)
7
Reset Control(+)
9
NC
HD LED (Hard Dr ive LED Connector)
This connector can be at
flicker during disk activi ty. This disk activity only applies to those IDE dr
system board.
RST (Reset Butt on)
This connector can be attached to a momentary SPST switch. This switc
When closed it will cause the mainboard to reset and run the POST (Power On S
PWR-LED (2-pin Power LED Connector)
The mainboard provide s two power LED connector.If there is a 2-pin power
panel of a computer case. You can attach it to the 2-pin power LED connector. The LED will
illumi nate while the computer is powered on.
PWR ON (P ower Butt
This connector can be attached
pin to ground fo r at least 50 m
due to internal debounce circuitry n the syste
power supply will recognize another on/off
PWRLED (3 -Pin Power
The mainboard provides two power LED connect
panel of a computer case. You can attach it to the 3-pin power LED connector.
he front panel of your computer.
NC
+ -
1
PWRLE D
1 2 (+)
3 4 (-)
5 6 (+)
8 (-)
7
9 1 0
SWLE D
2
Hard Drive
4
LED
6
Reset
8
Button
10
NC
tached to an LED on the front panel of a comput
on )
to a front panel p ow sw er
s to si gnal th e pow er s ply to switch on
o m boar ). At least two sec
signal.
LED Connector)
or. If
13
PM266A PRO/ PM266A
Power LED (+) POWER
Power LED (-)
Power Button(+) Power-on
Power Button(-) Button
NC
er case. The LED will
ives directly attached to the
h is normally left open.
elf Test).
LED cable on the front
itch. The switch m ust pull the Po
up or off (the tim
d ond s must pass
there is a 3-p in power LE D cab
LED
NC
wer Button
e required is
before the
le on the front