Paper Menu - Canon imagePROGRAF iPF650 User Manual

Paper Menu

Setting Item
Load Paper
Eject Paper
Chg. Paper Type ( *1
Chg. Paper Size
ManageRemainRoll
Paper Details (The type of pa-
per is displayed
here.)
( *1
iPF650
)
→P.676
Head Height
Skew Check
)
→P.676
Lv.
Cutting Mode
Cut Speed
Trim Edge
First
CutDustRe-
duct.
Vac-
uumStrngth
Description, Instructions
Select sheets or rolls and load the paper.
Choose this item before removing loaded paper.
Change the type of paper loaded. (See "Changing the Type
of Paper.")
→P.583
Change the size of paper loaded. (See "Specifying the Paper
Length.") (See "Paper Sizes.")
→P.585
Choose On to print a barcode at the end of a roll before you
remove it. The printed barcode can be used in managing the
amount of roll paper left. Choose Off if you prefer not to print
the barcode.
(See "Keeping Track of the Amount of Roll Paper Left.")
→P.591
Adjust the Printhead height. (See "Troubleshooting Paper
Abrasion and Blurry Images (Head Height).")
If you print on Japanese paper (washi) or other handmade pa-
per that has an irregular width, choose Loose for a higher
skew detection threshold, or choose Off to disable skew de-
tection. However, if paper is loaded askew when detection is
Off, note that paper jams or Platen soiling may occur.
Specify whether or not to cut with the standard round-bladed
cutter.
Choose Automatic to have the roll cut automatically after
printing. If you choose Manual, the paper will not be cut after
printing. Instead, a line will be printed at the cut position.
Choose Eject if you prefer not to have documents dropped
immediately after printing, as when waiting for ink to dry.
Choose the cutting speed. If you use adhesive paper, choosing
Slow helps prevent adhesive from sticking to the cutter and
keeps the cutter sharp.
If a roll is loaded, the end of the paper will be cut.
If you choose On, a line will be printed at the cut position
when paper cutting is selected. This option reduces the
amount of debris given off after cutting. It also helps prevent
adhesive from sticking to the cutter and keeps the cutter sharp
if you use adhesive paper. (See "Reducing Dust from Cut-
ting Rolls.")
→P.601
Specify the level of suction that holds paper against the Plat-
en. (See "Adjusting the Vacuum Strength (Vac-
uumStrngth).")
→P.636
Control Panel > Printer Menu >
→P.569
→P.626
Menu Settings
8
675