End Of Paper Feed; Rel Lever Is In Wrong Position; Borderless Printng Not Possible - Canon imagePROGRAF iPF765 User Manual

iPF765
Cause
There are sheets left on the
Ejection Guide.
There is a foreign object by the
Output Tray, obstructing the Cut-
ter Unit.
You are not using the printer un-
der the recommended environ-
mental conditions for the paper.
You are using paper that is not
compatible with automatic cut-
ting.
In other cases, the Cutter Unit
may be damaged.

End of paper feed.

End of paper feed.
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.

Rel lever is in wrong position.

Rel lever is in wrong position.
Cause
The Release Lever is pushed back.

Borderless printng not possible.

Borderless printng not possible.
Cause
The print job received specifies a type
or width of paper that is not compatible
with borderless printing.
The loaded paper is a size not compati-
ble with borderless printing.
User's Guide
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.")
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions for paper, see Paper Reference Guide."
(See Paper Reference Guide .)
1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See Paper Reference Guide .)
2.
Push the Release Lever back and remove the paper.
Contact your Canon dealer for assistance.
Cause
Corrective Action
Pull the Release Lever forward.
Turn off the printer and wait a while before restoring power.
Follow these steps to change the settings of the print job to enable borderless printing.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Make sure the correct printer driver for the printer is selected and try printing again.
For information on types of paper compatible with borderless printing, refer to the Paper Refer-
ence Guide.
(See Paper Reference Guide .)
Select None when you have set Detect Mismatch on the control panel to Warning.
However, note that this error may cause paper jams and affect the printing quality.
Press ▲ or ▼ to select Print With Border, and then press the OK button to continue printing. The
document will be printed with a border.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Replace the paper with paper compatible for borderless printing as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
Corrective Action
→P.446
→P.458
Corrective Action
Release the ▲ button.
Corrective Action
→P.451
→P.454
→P.443
→P.446
End of paper feed.
693