Cannot Print Over A Network; Cannot Connect The Printer To The Network; Cannot Print Over A Tcp/Ip Network; Cannot Print Over A Netware Network - Canon imagePROGRAF iPF765 User Manual

Large format printer
Hide thumbs Also See for imagePROGRAF iPF765:
Table of Contents

Advertisement

Cannot connect the printer to the network

Cannot print over a network

Cannot print over a network

Cannot connect the printer to the network ......................................................................................................... 672

Cannot print over a TCP/IP network ................................................................................................................... 672

Cannot print over a NetWare network ................................................................................................................ 672

Cannot print over AppleTalk or Bonjour networks ............................................................................................. 673
Cannot connect the printer to the network
Cannot connect the printer to the network
Cause
The Ethernet cable is
not connected correct-
ly to the printer's
Ethernet port.
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
The printer's IP address is not configured correctly.
The printer's TCP/IP network settings are not config-
ured correctly.
The computer you are trying to print from is not con-
figured correctly.
Cannot print over a NetWare network
Cannot print over a NetWare network
Cause
The printer's NetWare settings
are not configured correctly.
The computer you are trying
to print from is not configured
correctly.
672
The NetWare server and serv-
ices are not configured cor-
rectly.
1.
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer on. For
instructions on connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The bottom indicator is green if the printer is connected via 1000Base-T, while the top indicator is orange if con-
nected via 100Base-TX and the top indicator is green if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
Make sure the hub is on.
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate automatically (in auto
negotiation mode), sometimes the hub settings cannot be detected. In this case, configure the connection meth-
od manually, specifying the communication mode in use.
(See "Configuring the Communication Mode Manually.")
Cause
Make sure the printer's IP address is configured correctly.
Make sure the printer's TCP/IP network settings are configured correctly.
Make sure the computer's TCP/IP network settings are configured correctly.
Make sure the printer's NetWare settings are configured correctly. In particular, make sure a valid frame type
is selected.
(See "Configuring the Printer's NetWare Network Settings With RemoteUI.")
Make sure the computer's NetWare settings are configured correctly.
(See "Configuring NetWare Network Settings.")
Check the following points.
1.
Make sure the NetWare file server is running.
Corrective Action
→P.559
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.")
(See "Configuring the IP Address Using the Printer Control Panel.")
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")
(See "Configuring the Printer Driver Destination (Windows).")
(See "Configuring the Destination in TCP/IP Networks.")
Corrective Action
→P.544
Corrective Action
→P.537
→P.540
→P.552
→P.549
iPF765
→P.308
→P.541
User's Guide

Advertisement

Table of Contents
loading

Table of Contents