Nav/Com/XPDR/Audio Panel
Symptom(s)
"3D audio left"
message heard
in left ear only,
no audio heard
in right ear.
"3D audio right"
message heard
in right ear only,
no audio heard
in left ear
VOICE RECOGNITION
Voice Recognition allows the pilot (and optionally copilot) to control the GMA
350H using spoken commands. To activate Voice Recognition, push and hold the
Push-To-Command (PTC) button while speaking a command. When the Push-To-
Command button is released, the GMA 350H will respond.
If a command is correctly interpreted by the GMA 350H, a positive acknowlege-
ment chime will be played, and the pilot should verify that the correct button selection
is indicated by the triangular annunciator lights. Alternatively, some commands will
be indicated by a voice response from the GMA 350H. If the desired modes are not
indicated by annunciator lights or a voice response, the pilot should repeat the com-
mand by using the Push-To-Command button, or by manually using the front panel
controls of the GMA 350H.
If a command is incorrectly interpreted by the GMA 350H, a negative acknowlege-
ment tone will be played. The pilot should repeat the command by using the Push-
To-Command button, or by manually using the front panel controls of the GMA 350H.
In the event of any abnormal Voice Recognition operation, at any time the front panel
controls may be used manually to control the GMA 350H.
The following table lists the available Voice Recognition commands, the associated
actions, and the voice response if applicable:
22
Garmin G1000H
3D Audio Troubleshooting
Cause(s)
1) Aircraft wired for mono
intercom
1) Incorrect aircraft wiring
(right channel used for
mono instead of left, or
left/right swapped)
3D Audio Troubleshooting
Cockpit Reference Guide for the Bell 407GX
™
Solution(s)
1) See a service center to wire the
installation for stereo headsets.
1) See a service center as soon as
possible to inspect/correct wiring.
This wiring fault can cause fail-safe
audio not to function.
190-01254-00 Rev. B