Garmin Beil 407GX Cockpit Reference Manual page 150

Appendix
6) Again, press any key to continue as instructed on the display.
7) Press the NO Softkey. The display now starts in normal mode. Since the
database effective date is not yet valid, it should not be loaded as the
active database. The display now starts in normal mode. Do not remove
power while the display is starting.
8) Press the ENT Key to acknowledge the startup screen.
9) Turn the large FMS Knob to select the AUX Page group on the MFD.
10) Turn the small FMS Knob to select the System Status Page.
11) The new database is copied to the SD card in the bottom card slot of each
PFD. Progress can be monitored in the SYNC STATUS field. When copying
is finished, 'Complete' is displayed.
NOTE: During the synchronization process, version differences between
standby navigation databases will exist. This will result in the system
displaying a 'DB Mismatch' alert for the standby navigation databases. This
alert will remain until the next power cycle.
12) Turn system power OFF.
13) Remove the SD card from the top card slot of the MFD.
14) Turn system power ON.
15) Press the ENT Key to acknowledge the startup screen.
16) Turn the large FMS Knob to select the AUX Page group on the MFD.
17) Turn the small FMS Knob to select the System Status Page.
18) Press the Display Database Selection Softkey to show standby navigation
database information for each display (MFD1 DB, PFD1 DB). Verify the
correct standby navigation database cycle information is shown for each display.
Magnetic Field Variation Database Update
At startup, the system compares this version of the MV DB with that presently being
used by the AHRS (GRS). If the system determines the MV DB needs to be updated,
a prompt is displayed on the Navigation Map Page, as shown in the following figure.
134
Garmin G1000H Cockpit Reference Guide for the Bell 407GX
™
190-01254-00 Rev. B