Cabling The G650 Media Gateways; Cabling Two Media Gateways - Avaya G650 Installing

Avaya media gateway
Hide thumbs Also See for G650:
Table of Contents

Advertisement

Cabling the G650 Media Gateways

After mounting the G650 Media Gateways in the rack, you must connect the TDM/LAN cables between
them. You must also connect CAT5 cables to the appropriate slots on the back of the media gateways.
You can mount and cable up to five media gateways in a rack. The media gateway on the bottom is
referred to as media gateway A. The others are referred to as media gateways B, C, D, and E from bottom
to top.
When cabling the media gateways together, see the G650 TDM/LAN Cable Installation diagram included
with the shipment.
Perform these tasks to cable the G650 Media Gateway:

Cabling two media gateways

Cabling the third media gateway
Cabling the fourth media gateway
Cabling the fifth media gateway
Installing circuit packs in the G650 Media Gateway
Cabling two media gateways
To cable two media gateways:
1
If not already removed, remove the fan assemblies from media gateways A and B.
2
Remove the right TDM/LAN bus terminator from media gateway A, and install it at the left end
of the TDM/LAN bus on media gateway B.
!
Make sure to install the TDM/LAN bus terminators with the arrow on the back pointing upward.
3
Loosen the nuts on the posts of the plate covering the bottom right TDM/LAN cable routing slot
of media gateway B and remove the plate.
4
Remove the right slot cover on top of media gateway A and the lower right slot cover of media
gateway B to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place. Make sure the open corner of
the gasket faces the rear of the media gateway. Once installed, the top media gateway should rest
on and compress the gasket.
6
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus in media
gateway A.
!
Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the right end of the TDM/LAN bus in
media gateway B.
Installing the Avaya G650 Media Gateway
June 2004
on page 51
on page 52
on page 53
WARNING:
WARNING:
on page 52
on page 54
51

Advertisement

Table of Contents
loading

Table of Contents