Mounting One G650 Media Gateway - Avaya G650 Installing

Mounting one G650 Media Gateway

To mount one G650 Media Gateway:
1
Remove the G650 Media Gateway door by opening and then lifting it straight up and off the hinge
pins.
!
When handling circuit packs or any components of the G650 Media Gateway, always wear an
authorized wrist ground strap connected to the ground connector provided on the G650. Always
store the circuit packs to protect them from damage by electrostatic discharge.
2
Remove all circuit packs and the power supplies.
3
To place the G650 Media Gateway in the medial position:
a
b
c
4
Use the mounting template to locate a set of rack holes that you can use for mounting the G650
Media Gateway. Note the position of the upper key-hole shaped slots on each rail.
Installing the Avaya G650 Media Gateway
June 2004
NOTE:
In a multiple G650 Media Gateway configuration, put the G650s in the rack with no
vertical space between them. If the G650 Media Gateways are not mounted adjacent with
their fronts in the same vertical plane, the TDM/LAN cable(s) cannot connect them.
NOTE:
Avaya recommends that the first G650 Media Gateway be installed in the lowest position
as carrier A (see Figure 2, G650 Media Gateway stack (A through E) installed next to the
media server rack, on page 33). This facilities mounting carriers B through E directly
above carrier A.
WARNING:
Remove the screws on the mounting brackets.
Move the brackets to a position midway on the G650 Media Gateway.
Reinstall the screws through the mounting bracket and into the G650 Media Gateway
holes.
NOTE:
The mounting screw holes in commercial racks are not evenly spaced. Ensure the holes
you select for mounting the G650 Media Gateway match all the mounting bracket slots on
the mounting template. See
placement, on page 38.
Figure 6, Rack hole spacing and first mounting screws
37