3
Connecting the media gateway to
the
main distribution frame
Once the main distribution frame (MDF) is installed and wired, you must connect the media gateways to
the MDF.
Run excess cables on an upper cable ladder (if the MDF connectors are on top) or route them through a
cable slack manager that is placed next to the MDF. For more information, see
Managers
on page 113.
This section has information about
•
Equipment room cabling labels
•
Cable routing guidelines
•
Trunk cables among network interface, sneak fuse panel, and media gateway
And procedures for:
•
Installing cables between media gateway and main distribution frame
•
Installing connector cables between auxiliary cabinet (if used) and main distribution frame
page 122
Equipment room cabling labels
The purple port label shown in
both ends of the 25-pair cables connecting to the trunk/auxiliary field and/or distribution field.
Installing the Avaya G650 Media Gateway
June 2004
Connecting the media gateway to the main distribution frame
on page 117
on page 119
Figure 55, Equipment room cabling labels,
Installing Cable Slack
on page 121
on page 121
on
on page 118 is installed on
117