Cabling The Third Media Gateway; Cabling The Fourth Media Gateway - Avaya G650 Installing

8
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the
routing slots are covered.
9
If finished, reinstall the fan assemblies and tighten the 7 screws. (All knurled screws must be
tightened securely so that they cannot be loosened without the use of a tool.) Otherwise continue
to

Cabling the third media gateway

Cabling the third media gateway
To cable the third media gateway:
1
If not already removed, remove the fan assemblies from media gateways B and C.
2
Remove the left TDM/LAN bus terminator from media gateway B, and install it at the right end of
the TDM/LAN bus in media gateway C.
3
Remove the nuts on the posts of the plates covering the bottom left TDM/LAN cable routing slot
of media gateway C and the top left TDM/LAN cable routing slot of media gateway B.
4
Remove the left slot cover on top of media gateway B and the lower left slot cover of media
gateway C to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place.
6
Install the lower terminator of the TDM/LAN bus cable on the left end of TDM/LAN bus in
media gateway B. Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the left end of the TDM/LAN bus in
media gateway C.
8
Flip over the routing slot plates and reinstall both. Once the plates are reinstalled, the ends of the
routing slots are covered.
9
If finished, reinstall the fan assemblies and tighten the 7 screws. (All knurled screws must be
tightened securely so that they cannot be loosened without the use of a tool.) Otherwise continue
to

Cabling the fourth media gateway

Cabling the fourth media gateway
To cable the fourth media gateway:
1
If not already removed, remove the fan assemblies from media gateways C and D.
2
Remove the right TDM/LAN bus terminator from media gateway C, and install it at the left end of
the TDM/LAN bus in media gateway D.
3
Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable routing slot
of media gateway D and the top right TDM/LAN cable routing slot of media gateway C.
4
Remove the left slot cover on top of media gateway C and the lower left slot cover of media
gateway D to open the slots.
5
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in both
media gateways. Push the free end of the EMI Gasket back in place.
6
Install the lower terminator of the TDM/LAN bus cable on right end of TDM/LAN bus in media
gateway C. Make sure the arrows on the back of the cable terminators point upward.
7
Install the upper terminator of the TDM/LAN bus cable on the right end of the TDM/LAN bus in
media gateway D.
52
on page 52.
on page 52.
Installing the Avaya G650 Media Gateway
June 2004