Chapter 3: Connecting The Media Gateway To The Main Distribution Frame129; Equipment Room Cabling Labels - Avaya G650 Installing

Chapter 3: Connecting the media gateway to the
Once the main distribution frame (MDF) is installed and wired, you must connect the media
gateways to the MDF.
Run excess cables on an upper cable ladder (if the MDF connectors are on top) or route them
through a cable slack manager that is placed next to the MDF. For more information, see
Installing Cable Slack Managers
This section has information about

Equipment room cabling labels

Cable routing guidelines
Trunk cables among network interface, sneak fuse panel, and media gateway
page 134
And procedures for:
Installing cables between media gateway and main distribution frame
Installing connector cables between auxiliary cabinet (if used) and main distribution
frame on page 135
Equipment room cabling labels
The purple port label shown in
installed on both ends of the 25-pair cables connecting to the trunk/auxiliary field and/or
distribution field.
main distribution frame
on page 126.
on page 131
Figure 55: Equipment room cabling labels
on page 129
on
on page 135
on page 130 is
Issue 2 January 2005 129