Install Main Distribution Frame (Mdf) And External Modem - Avaya CMC1 Installation Manual

Install Main Distribution Frame (MDF) and External
Modem
Install Main Distribution Frame
(MDF) and External Modem
Install the MDF
!
CAUTION:
The optional MDF is a special 110 cross-connect field and is smaller than standard 110
cross-connect hardware. Do not install standard 110 hardware inside the right panel.
NOTE:
The depth of any equipment installed inside the right panel must not exceed 2.5 inches
(6.3 cm), otherwise the right cover panel cannot fit over the right panel.
The optional MDF represents the trunk/auxiliary field.
1. Mount the optional MDF to the right panel using one of the following:
Bottom-mounted MDF with Modem
1. On the rear of the MDF, cut the cable tie securing the top 5 cables to the
MDF mounting frame.
2. Mount the MDF to the right panel. See
3. Secure all 10 cables to the bottom left bracket on the MDF with a cable tie.
555-233-118
For bottom-mount MDFs, refer to
Modem'' on page 1-29.
For top-mount MDFs (in cabinets other than cabinet A),
refer to ''Top-Mounted MDF'' on page
For dual-mount MDFs, refer to
''Bottom-mounted MDF with
1-31.
''Dual MDFs'' on page 1-32.
Figure 1-16 on page 1-30.
Issue 7 November 2003
1-29