NETGEAR ProSafe FVS318N Reference Manual page 369

IPv6 WAN Port Status

To view the IPv6 status of the WAN port:
Select Network Configuration > WAN Settings > Broadband ISP Settings (IPv6).
1.
The Broadband ISP Settings (IPv6) screen displays (see
2. Click the Status option arrow in the upper right of the screen to display the Connection
Status pop-up screen. (The following figure shows a dynamic IP address configuration.)
Figure 221.
The type of connection determines the information that is displayed on the Connection
Status screen. The screen can display the information that is described in the following
table:
Table 91. Connection Status screen information for an IPv6 connection
Item
Connection Time
IPv6 Connection Type
IPv6 Connection Status
IP Address
Gateway
Primary DNS Server (IPv6)
Secondary DNS Server (IPv6)
Click Disconnect to disconnect the connection; click Connect to establish the
connection.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Description
The period that the wireless VPN firewall has been connected through the
WAN port.
The connection type can be either Dynamic IP (DHCP), Static, or PPPoE.
The connection status can be either Connected or Disconnected.
The IPv6 addresses that were automatically detected or that you
configured on the Broadband ISP Settings (IPv6) screen.
Note: The Gateway and DNS Server (IPv6) fields apply only to static IPv6
and PPPoE IPv6 connections.
Note: For more information, see
IPv6 Internet Connection
Connection
Monitor System Access and Performance
Figure 19
Use a DHCPv6 Server to Configure an
on page 39 and
on page 41.
369
on page 40).
Configure a Static IPv6 Internet