Installation Instructions; Clearances - Cannon CANTIB User Instructions

Installation Instructions

Clearances

Installation into a
fireplace.
10
1. This appliance is to be installed by a licensed service person
only.
2. This appliance is to be installed in accordance with the
manufacturer's installation instructions, AS 5601/AG 601,
Municipal Building Codes, Electrical Wiring Regulations and
any other statutory regulations.
3. Ensure the minimum clearances to combustible construction are
maintained during installation, including adequate space for
the proper operation and servicing of the heater.
Keep curtains*, furniture and other flammable materials at least
900mm from front of heater.
* Curtain clearance can be less than 900mm as long as they
are restained from sides and front of heater.
For minimum clearances refer fig 9 and 10.
Note: Ensure that the combustion air opening under the heater
is not obstructed.
9
4. Models CANTIB & CANTIBLP should only be installed into a
masonry or brick fireplace.
Models CANTIBM & CANTIBMLP can be installed into a mock
fireplace.
5. Prepare electrical and gas connections, a 10 Amp wall socket
needs to be located within 1.5m of the heater. Hard (fixed)
wiring connection is to be carried out only by a qualified elec-
trician.
6. Remove the heater from the carton and remove the three transit
screws.
(Please dispose of packaging appropriately, keep away from
children).
7. Remove the front glass surround by holding it firmly on either
side and pulling it towards yourself, see figure 11.
10